Talc Powder 1250 Mesh
1250 mesh talc powder with stable 30% SiO₂ and ≥93 whiteness. D50 6 µm, D97 ≤12 µm — a fine talc filler for modified plastics, EVA foaming and premium rubber…
View Talc Powder 1250 MeshMineral powders serve as functional fillers in plastic manufacturing, improving mechanical strength, dimensional stability, and heat resistance while reducing material costs.
Mineral powders serve as functional fillers in plastic manufacturing, improving mechanical strength, dimensional stability, and heat resistance while reducing material costs.
Send us your formulation target and we will propose a grade with a TDS and free sample.
1250 mesh talc powder with stable 30% SiO₂ and ≥93 whiteness. D50 6 µm, D97 ≤12 µm — a fine talc filler for modified plastics, EVA foaming and premium rubber…
View Talc Powder 1250 MeshPrivate label in minerals is a specification decision wearing a brand. What OEM transfers, why the mesh number under your logo needs a named test…
Read articleTalc in coatings is a functional filler, not a cheap white: lamellar barrier effect, anti-settling, sanding and matting, the oil absorption…
Read articleMost factory audits produce a folder of photocopies and a recommendation that answers nothing. This checklist treats the audit as a measurement:…
Read articleThere is no single answer, because the right grade depends on the polymer, the loading ratio and the surface finish you need. In practice finer talc is used where surface appearance and dispersion matter, while coarser grades are chosen where stiffness and cost dominate. Tell us your polymer, target loading ratio and the finish requirement, and we will send 2–3 candidate grades with samples so you can run a real comparison rather than infer from a datasheet.
Yes. Each batch can be issued with a certificate of analysis covering the parameters that matter for your application — whiteness, particle size, moisture and, where relevant, chemical composition. We also work with third-party inspection such as SGS when you prefer an independent report. Ask for the COA scope in writing on the proforma invoice so there is no ambiguity at customs clearance.
The standard MOQ is one 20 ft container, roughly 25–27 tonnes depending on grade and packaging. If you would rather qualify the material before committing a full container, we can usually split a trial across two grades in the same shipment so you compare them on one arrival. Tell us which grades you want to compare.
Our mineral powders enhance coating opacity, brightness, and weather resistance. They serve as extender pigments that improve film properties and…
View Coatings & Paint applicationsCalcium carbonate and talc powders are essential in paper making as fillers and coating pigments, improving paper brightness, opacity, and…
View Paper applicationsMineral fillers reinforce rubber compounds, improving tensile strength, tear resistance, and processing characteristics in tire and industrial…
View Rubber applicationsDolomite powder provides essential MgO and CaO for glass batch formulations, while talc serves as a flux agent in ceramic body and glaze compositions.
View Glass & Ceramics applicationsThe quotations below are taken verbatim from published standards; each link goes to the issuing body's official page.
“This document gives the definition for the term extender and specifies test methods that are required for most of the subsequent parts of ISO 3262.”
— ISO — International Organization for Standardization, ISO 3262-1:2020, Extenders — Specifications and methods of test — Part 1: Introduction and general test methods, official source
“ISO 3310-1:2016 specifies the technical requirements and corresponding test methods for test sieves of metal wire cloth. It applies to test sieves having aperture sizes from 125 mm down to 20 µm, in accordance with ISO 565.”
— ISO — International Organization for Standardization, ISO 3310-1:2016, Test sieves — Technical requirements and testing — Part 1: Test sieves of metal wire cloth, official source
Tell us your target mesh size, whiteness and application. We send samples and a quotation within 24 hours.