Free Sample Process for Mineral Powder Buyers: From Request to Approval
A free sample is the cheapest risk control in mineral powder buying, but only when the request, the paperwork and the incoming checks are done…
Read articleTalc (Mg3Si4O10(OH)2) and calcium carbonate (CaCO3) are the two most common mineral fillers but are not interchangeable. Compare hardness, particle shape, oil absorption and the applications where each wins, with a quick decision checklist.
Both are white powder fillers, so buyers often ask which to specify. Talc wins on stiffness, heat resistance and low abrasion; calcium carbonate wins on brightness and cost per tonne. The choice is decided by what the part has to do.
Published · Updated · By TDHX Minerals
Talc is hydrous magnesium silicate (Mg3Si4O10(OH)2), Mohs hardness 1, lamellar (plate-like). Our standard TDHX-TALC-2023-07 runs SiO2 20–65%, whiteness 70–97%. Ground calcium carbonate is natural calcite (CaCO3), Mohs hardness 3, blocky to aggregated; our TDHX-CC-2023-07 runs CaCO3 88–98%, whiteness 75–97%.
Talc is softer, lower in oil absorption and reinforces by platelets; calcium carbonate is harder, brighter and cheaper per tonne. A simple rule: need stiffness, heat deflection and low screw or roll wear → talc; need maximum brightness at volume and lowest cost → GCC.
Choose talc for polypropylene, masterbatch and engineering plastics where stiffness, heat deflection temperature and low abrasion on processing equipment matter, and in coatings for matting, anti-settling and sandability.
Choose calcium carbonate for cost-sensitive bulk plastics, paints, sealants, adhesives, rubber and paper where high brightness and low price lead. For precipitated (engineered) grades, see our GCC vs PCC guide.
1) Stiffness and heat resistance required → talc. 2) Brightness above 95% at the lowest cost → GCC. 3) Slip or anti-blocking in film → talc. 4) Bulk filler in PVC, cable or mortar → GCC. 5) Coating matting and sandability → talc.
If two needs conflict, tell us the application and we will propose talc, GCC or a blend, with TDS and free samples.
Send your application and any existing specification; we propose talc, GCC or a blend, with TDS and free samples, rather than leaving you to guess from a catalogue.
For dolomite or magnesium options, see our other guides.
A free sample is the cheapest risk control in mineral powder buying, but only when the request, the paperwork and the incoming checks are done…
Read articleWhat a mineral powder certificate of analysis should state for a shipment — lot number, sampling basis, test methods, specification limits and a…
Read articleTwo suppliers can quote on the same product name and still ship material that behaves differently in your process. This guide covers the practical…
Read articleThe quotations below are taken verbatim from published standards; each link goes to the issuing body's official page.
“This document specifies requirements and corresponding methods of test for products made from naturally occurring talc/chlorite in lamellar form.”
— ISO — International Organization for Standardization, ISO 3262-10:2024, Extenders — Specifications and methods of test — Part 10: Natural talc/chlorite in lamellar form, official source
“This document gives the definition for the term extender and specifies test methods that are required for most of the subsequent parts of ISO 3262.”
— ISO — International Organization for Standardization, ISO 3262-1:2020, Extenders — Specifications and methods of test — Part 1: Introduction and general test methods, official source
Tell us your target mesh size, whiteness and application. We send samples and a quotation within 24 hours.